operating distance
800mm
robust plastic housing, compact design
Teach in-based setting
LED display for fine adjustment
reduction in the level of reciprocal optical interference
connection with 4-pin M8-connector
Technical data
version
object recognition
background position (Sde)
50 … 800mm
detection range (Sa)
96% of Sde
operating voltage U
B
10 … 30V DC
current consumption (w/o load)
≤ 35mA
output current (max. load)
≤ 100mA
output signal
push-pull, no/nc
voltage drop (max. load)
≤ 2V DC
reaction- /decay time
≤ 1.8msec
sampling frequency
≤ 270Hz
short-circut protection
+
reverse polarity protection
+
display (signal)
green LED
display (status) / setting control
red LED
transmitting element
red LED, 660nm, pulsed
light spot size
housing material
front screen material
system of protection
Ø
15mm at 800mm
plastic (ASA-MABS)
PMMA
IP67 (EN 60529)
operating temperature
-30°C … +60°C
connection
max. tightening torque
M8-connector, 4-pin
0.8Nm
description:
These completely new through-beam sensors work according to the principle established with the retro-reflective
sensor. With these devices however, no retro-reflector is used. Any flat surface can be used as a reflector, e.g. the wall
of a piece of machinery.
This is `teached in' as a background item, via the Teach-In line (white wire, PIN 2). Each object that is located between
the sensor and background position is detected. This induces a change to the signal at the switch output. The system is
highly nonsensitive to soiling, however the background should not change whilst the device is running.
new: works like a retro-reflective
sensor - but without a reflector
ON430570
MANUAL
• Subject to alteration! Version:
November 2012
ipf electronic gmbh
• Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
www.ipf-electronic.com
1
