LIP-9071
iPKTS
User Guide
9
3 Power up and Setup Wizard
When connected to power, the phone will perform Setup Wizard for language selection. This step ‘Setup Wizard’
only should be performed in the factory default of the phone.
3.1 Language Selection
When connected to power, the phone will perform
language selection. User can choose Language to
be used for the Phone. Base on this selection, the
software keyboard and IME for phone will be
changed.
3.2 Protocol Selection
After select language it could be guided to select
call protocol. To use LIP-9071 as iPECS iPKTS
phone, choose iPKTS protocol from below selection
screen. Then will restart automatically.
3.3 Registration
When connected to power and the network, the phone will perform its power-up routine and then attempt to locate
and register with iPECS system. During the process the display will indicate status including ‘Searching for MFIM’,
which is iPECS call server. In a default configuration, iPECS will permit registration of the phone, and will assign a
station number and other characteristics to the phone. Once complete the phone is fully operational and displays
the Home screen with the Station Number and status (On Line) shown above the clock.
If iPECS network settings have been changed or the phone is installed in a remote location, the phone will not be
able to complete registration. The phone screen will display a No Acknowledgement or other fault message. In this
case, assistance of iPECS administrator may be required. iPECS may require configuration to allow registration of
LIP-9071. In addition, the IP settings of the phone and the System Configuration data may require modification with
the assistance of iPECS administrator.
