IPC CT105 BT70 Traction, Руководство оператора

Страница: 18 / 37

GB
► check that the electrolyte level is still above the plates, otherwise top up with the solution
of sulphuric acid;
► reclose the plugs;
► install the storage batteries on the machine (following the procedure described below).
It is now necessary to perform a first recharging before having the machine start; to do so stick to
the instructions written in the respective paragraph.
Batteries: installation and connection
DANGER
Check that the emergency button on the control panel is at the position “0” (off).
Mind you connect only the clips marked with the symbol “+” to the positive poles. Do not
check the battery charge by creating sparkles.
Stick scrupulously to the instructions described below, as any short circuits of the batteries
may cause them to explode.
► Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake
by means of the pedal (fig. 8, ref. 12);
► make sure that the two tanks are empty (empty them, if necessary: see respective para -
graph);
► unhook the recovery tank (fig. 2, ref. 2) from the solution tank (fig. 2, ref. 3) acting on the
blocking hook (fig. 7, ref. 1), placed on front of the machine;
► lift the recovery tank, by making it turn backwards around about 90°: in this way you have
access to the battery compartment (embedded in the solution tank) from the upper side;
WARNING
Before opening the upper tank:
ensure that the recovery tank is empty (an acoustic warning device will sound if you try to
open the recovery tank without emptying it first);
ensure that the emergency button is pressed.
► insert the batteries in the compartment, orienting them as shown in the drawing printed on
the solution tank in the compartment.
WARNING
Install the storage batteries on the machine using suitable means according to their weight.
Positive and negative poles have different diameters.
► Referring to the arrangement of cables in the aforesaid drawing, connect the clips of the
battery wiring and the bridge to the poles of the storage batteries. After orienting the cables
as shown in the drawing, tighten the clips at the poles and cover them with vaseline;
► insert back the tank unit in its work position and hook it to the solution tank by means of
the fixing hook (fig. 7, ref. 1);
► use the machine in compliance with the instructions written below.
Batteries: removal
DANGER
When removing the batteries, the operator must be equipped with suitable personal protec -
tion devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk of accidents.
Make sure the switches on the control panel are in the “0” position (off) and the machine is
turned off. Keep away from naked flames, do not short circuit the battery poles, do not cause
sparks and do not smoke. Proceed as follows:
► disconnect the battery wiring and bridge terminals from the battery poles.
► if necessary, remove the devices fixing the battery to the base of the machine.
► lift the batteries from the compartment using suitable lifting equipment.
18