Quick Manual
Neutron3-B+ Remote Pulse Collector
Copyright 2020 - ionSign
www.ionsign.fi
15.6.2020
– v1.4
Introducing Neutron3-B:
1.
Insert SIM card to its slot, PIN query disabled.
2.
Connect the measuring device(s).
3.
Insert the battery or remove the battery cover.
The red led lights up for 10 seconds.
4.
Enter the installation mode by pressing the but-
ton inside the device or activating it with a mag-
net from the outside. The device wakes up for
five minutes to receive SMS messages. The
red GSM led double blinks when GSM network
search is active, and blinks when a GSM con-
nection is established.
5.
Send a SETTINGS command to the device as
an SMS. When the command is received, the
yellow led starts blinking and the device starts
to establish a server connection. The yellow led
remains lit when the device is in operation.
6.
Securely close the lid and mount the device
e.g. to a wall.
When the installation mode times out, all leds switch off. This is normal.
The below example command sets device 101 to start collecting hourly pulse data and
send it to server services.ionsign.fi,
path /cloud/input/ and port 80, using
internet as APN. Device 101 has 4 in-
puts and data is sent one minute after
24 readings have been collected. In
this case, with hourly data, at 00:01.
Refer to section 4 on the next page
to compile your specific SETTINGS
command. Always establish your
specific SETTINGS parameters from
your reseller, service provider or
ionSign.
E.g. JAMAK 2x(2+1)x0,5mm2 instrumentation
cable can be used between Neutron3-B+ and the
meter. Connect the cable to the connector and
snap it in place to the terminal block. Cable polarity
has no significance.
GSM LED
Antenna
SIM card
Button
Battery
connector
Pulse connectors
LED
indicators
Device
ID
Attached
meters
Server
name
Server
port
Server
path
Transmission
delay
Operator
APN address
Measurement cycle:
15, 30 or 60 (min)
Example SETTINGS command:
SETTINGS
Command
60
