Quick Guide
Neutron12-LAN Remote Pulse Collector
Copyright 2017 - ionSign
www.ionsign.fi
15.3.2018
– v1.8
For
example
JAMAK
2x(2+1)x0,5mm2
instrumentation cable can be used between
the meter and Neutron12-LAN. The open
collector or relay output of a single meter is
connected to Neutron12-LAN as shown above.
Introducing Neutron12-LAN:
1.
Install Lantronix DeviceInstaller to your
workstation (
2.
Connect the power supply, meter(s), and
LAN cable as in the enclosed diagram.
Connect the device to the mains, the PWR
led lights up.
3.
Use a LAN cable to connect the device to
your workstation or the same LAN.
4.
Open the DeviceInstaller application, find
the device and make necessary settings.
Init led blinks when settings are in place.
Init led is lit continuously when the device
also has server connection.
5.
Data logging has commenced.
When in operation, the Signal led toggles between ON/OFF with every pulse received.
Connecting to the Device
The device is configured with the Lantronix DeviceInstaller application. The application
should be installed to a PC that is connected either to the same LAN with the device, or
directly to the device. If the LAN has an active DHCP server, Neutron12-LAN assumes
an IP address from the LAN, when powered up with default settings. Also a fixed IP ad-
dress may be used.
The device appears in the device list on the left, see picture. Firmware version v6.9.0.2
and device IP address 192.168.100.29 can also be found here. If the device does not
appear, click the
Search
button.
Click on the device IP address and choose the Web configuration tab on the right side of
the application window. If
a Lantronix configuration
page appears, do not
make any changes there.
In the address field, set
10001 as the port of the
device IP address (write
“:10001” after the IP in the
address field) and click on
the white arrow on the right
side of the field. The Set-
tings menu appears. Make
necessary settings ac-
cording to section 3 of user
guide.
