Quick Guide
Gluon GMU101 Smart Gateway
Copyright 2018
– ionSign Oy
www.ionsign.fi
17.5.2019
– v1.5
Commissioning the GMU101:
1.
Insert the SIM card to its slot. Disable PIN
query with a mobile phone, if enabled.
2.
Connect antenna, power supply and nec-
essary Modbus device(s).
3.
When powered up PWR led turns ON,
STA led flashes once and then STA and
STB leds flashes once simultaneously.
4.
The GSM led blinks twice when a 2G/3G
network is being looked for. GSM blinks
once when a network is available.
5.
Send the Settings
command SMS to the
SIM card
’s subscriber number. STA led
indicates
that
server
connection
is
established.
6.
Modbus master reading is configured on
the server application (e.g. ionSign Cloud)
7.
Data collection and transfer has started.
The example command sets device 121 to collect and transfer data with two-minute
intervals (120s) to server services.ionsign.fi, path /cloud/input/ and port 80, using
internet as APN. The device specific PIN code 1234 precedes the actual command.
Always establish your specific SETTINGS parameters from your reseller.
Operator
APN is usually found in their web site: Search for “[your operator] APN settings”.
•
The device only accepts messages with a correct PIN. Required for all commands.
•
Server Addresses are accepted in either
IP or DNS format. Protocol may be
appended to the address.
•
The device replies to all SMS commands,
e.g. to SETTINGS: ”Settings saved”.
•
To
all
commands
given
without
parameters, the reply SMS states the
current
status
or
active
settings.
”
<PIN>˽COMMAND
”
1234 SETTINGS 121 services.ionsign.fi 80 internet /cloud/input/ 120
PIN
ID
Device ID
(1…1 000 000)
Server
address
Operator
APN
Update interval
(
60…30 000 s)
Server
path
Server
port
For example JAMAK
2x(2+1)x0,5mm
2
instrumentation cable can
be used in fieldbus
wiring.
