Date Time
Set the system data and time. Enter into
“
System
”
→
”
Date Time
”
.
Daylight Saving Time:
The DST is a widely-used system of adjusting the local time forward to save energy. The uniform
time adopted during the implementation of this system is known as the DST. Typically, clocks are
adjusted forward one hour in the summer to make full use of illumination resources and save
electricity. Clocks are adjusted backward in autumn. The DST regulations vary with countries. The
device supports the DST function to adjust forward one hour at ×× (Hour): ×× (Minute) ×× (Day) ××
(Month) and backward one hour at ×× (Hour): ×× (Minute) ×× (Day) ×× (Month). For example,
adjust the clock forward one hour at 08: 00 on April 1 and backward one hour at 08: 00 on October
1. Daylight Saving Mode: Select the date mode or week mode. Daylight Saving Setup: Set the DST
start time and end time.
Note:
The end time of DST cannot be set for next year. More specifically, the end time must be later
than the start time in the same year.
Attendance
Enter into
“
System
”
→
”
Attendance
”
.
Parameters of Attendance interface state as below:
Duplicate Punch Period (m):
In set time period (unit: minute), repeated attendance record of a user
will not be saved (the valid time is 1~999999 minutes).
1.
Set Date/Time:
Set date and time of
device.
2.
24-Hour Time:
Whether to use the 24-hour
display mode. If not, the 12-hour display
mode is adopted.
3.
Date Format:
Set the date format: YY-MM-
DD, YY/MM/DD, YY.MM.DD, DD-MM-YY
etc.
