4
Ioline
THE I/S SIGNCUTTER
Thank you for purchasing an Ioline signcutter. To make signs, you also need
a computer with design software. After you have used the design software to
create a sign, you will send it as a cut file to the Ioline signcutter. The signcut-
ter will receive the file and cut the design. Check the following items before
you begin making signs:
• The design software, which helps you design signs, must be loaded into
the computer according to the installation instructions. If you have any
questions about the computer or the software, you will need to call the
dealer.
• The computer sends a cut file to the signcutter to create the signs. The
computer must be assembled and installed correctly before you connect
it, by cable, to the signcutter.
• The signcutter will cut the sign exactly as you have designed it. The sign
will be cut from the material that you have loaded into the signcutter.
• There is a specialized software program that comes with the signcutter
called the Ioline Control Center. You can load this software utility into a
PC compatible computer and use it to adjust signcutter settings and per-
form system diagnostics. Most design software provides drivers for Io-
line signcutters. Contact Ioline customer service if you need assistance
with drivers.
SAFETY AND PRECAUTIONS
Please read these safety guidelines before beginning operation of the signcut-
ter. The signcutter uses a very sharp blade when cutting. The parts can move
quickly. Always observe the following safety precautions:
• Do not allow the material to become suddenly taut between the plotter
and a roll of material during plotting. A service loop of unrolled material
is required for problem free operation. Using the Autoloop function (en-
abled in the Control Center) will create the required service loop by gen-
tly pulling a set amount of material from the roll before cutting. Ioline
recommends using the Autoloop function when plotting on a roll of ma-
terial.
• Do not try to repair the machine without factory authorization. Only quali-
fied service personnel should attempt any disassembly or access to inter-
nal components. If external mechanical adjustments are necessary, turn
off the signcutter and disconnect it from all power sources (both the com-
puter and the wall outlet).
• Be careful with hair, jewelry, or loose clothing near the signcutter. They
can become caught in the mechanical parts.
• Never move the carriage by hand. Use the Arrow keys and let the ma-
chine do it.
• Keep hands away from the carriage when the signcutter is in operation.
The carriage will automatically move to its right end position when the
power is turned on.
• Be careful when lifting the signcutter. Hold the bottom surfaces of the
signcutter to lift or move it.
• Keep fingers away from the drive shaft when the signcutter is in opera-
tion.
• Use caution when changing a blade in the blade holder. See the Routine
Maintenance chapter of this User Guide for the recommended proce-
dure.
• Be careful when handling the blades. They are sharp and could cause an
injury if mishandled. Although the blades are made of an extremely hard
material, they are brittle and can break if dropped or mishandled.