GD310-UL series VFD
Keypad operation procedure
-35-
5.3.2 Displayed state of running parameters
After the VFD receives valid running commands, the VFD will enter into the running state and the
keypad will display the running parameters. RUN/TUNE LED on the keypad is on, while the
FWD/REV is determined by the current running direction which is shown as figure 5-2.
In the running state, there are 24 parameters can be selected to be displayed or not. They are:
running frequency, set frequency, bus voltage, output voltage, output torque, PID given value, PID
feedback value, input terminals state, output terminals state, torque set value, length value, PLC and
the current stage of multi-step speeds, pulse counting value, AI1, AI2, AI3, HDI, percentage of motor
overload, percentage of VFD overload, ramp given value, linear speed, AC input current. P07.05 and
P07.06 can select the parameter to be displayed or not by bit and
》
/SHIFT can shift the parameters
from left to right, QUICK/JOG (P07.02=2) can shift the parameters from right to left.
5.3.3 Displayed state of fault
If the VFD detects the fault signal, it will enter into the fault pre-alarm displaying state. The keypad will
display the fault code by flicking. The TRIP LED on the keypad is on, and the fault reset can be
operated by the STOP/RST on the keypad, control terminals or communication commands.
5.3.4 Displayed state of function codes editing
In the state of stopping, running or fault, press PRG/ESC to enter into the editing state (if there is a
password, see P07.00).The editing state is displayed on two classes of menu, and the order is:
function code group/function code number
→function code parameter, press DATA/ENT into the
displayed state of function parameter. On this state, you can press DATA/ENT to save the parameters
or press PRG/ESC to retreat.
PRG
ESC
DATA
ENT
SHIFT
RUN
STOP
RST
QUICK
JOG
PRG
ESC
DATA
ENT
SHIFT
RUN
STOP
RST
QUICK
JOG
PRG
ESC
DATA
ENT
SHIFT
RUN
STOP
RST
QUICK
JOG
RUN/TUNE
FWD/REV
LOCAL/REMOT
TRIP
Hz RPM
A
%
V
RUN/TUNE
FWD/REV
LOCAL/REMOT
TRIP
Hz
A
V
RPM
%
RUN/TUNE
FWD/REV
LOCAL/REMOT
TRIP
Hz
A
V
RPM
%
Figure 5-2 Displayed state
5.4 Keypad operation
Operate the VFD via operation panel. See the detailed structure description of function codes in the
brief diagram of function codes.
Содержание GD310-011P-4-UL
Страница 1: ......
Страница 269: ...6 6 0 0 1 0 0 3 9 3 ...