he leakage current of the may be above
to fall inside
lease use the on
Cannot meet the requirements of low voltage protection in
o not carry the b
of the
loss
the with wet items or body, otherwise electric shock may
on the
he electrical parts and components inside the are e
o not refit the
or until the DC bus voltage is less than 36V.
Safety Precautions
2
1.4 Safety guidelines
Only qualified electricians are allowed to operate
Do not carry out any wiring and inspection or changing components when the
power supply is applied. Ensure all input power supply is disconnected before
wiring and checking and always wait for at least the time designated on the
Below
is the table of the
waiting time:
model
Minimum waiting time
380V 0R7G
–110G/132P
5 minutes
380V 132G/160P
–315G/355P
15 minutes
380V 355G/400P and higher
25 minutes
D
unauthorized;
otherwise fire, electric shock or other injury
may occur.
The base of the heat sink may become hot during running. Do not touch to
avoid hurt.
T
lectrostatic. Take
measurements to avoid electrostatic discharge during relevant operation.
1.4.1 Delivery and installation
Please install the
on fire-retardant material
and keep the
away from
combustible materials.
Connect the braking optional parts (braking resistors, braking units or feedback
units) according to the wiring diagram.
Do not operate
if there is any damage or components
Do not touch
occur.
Note:
Select appropriate moving and installing tools to ensure a safe and normal running
and avoid physical injury or death. For physical safety, the erector should take some
mechanical protective measures, such as wearing exposure shoes and working uniforms.
Ensure to avoid physical shock or vibration during delivery and installation.
D
y its cover. The cover may fall off.
Install away from children and other public places.
IEC61800-5-1
if the
altitude of installation site is above 2000m.
P
appropriate
condition (See chapter
Installation Environment
).
Don't allow screws, cables and other conductive items
T
3.5mA
during operation. Ground with proper
techniques and ensure the grounding resistor is less than
10Ω. The conductivity of PE
