E
group function, E29 group is factory reserved,
E8
"E
E28 are reserved.
function, of which E18
E
(E
For a better parameter protection,
( has limited the automatic
codes applying 3
contains certain function codes
Function parameters
29) according to the
ters have been divided into 30
Function Parameters
33
6
Function Parameters
6.1 What this chapter contains
This chapter lists and describes the function parameters.
6.2
The function parame
groups
00
–
–
Each function group
-level menus. For example,
08.08"
means the eighth function code in the
and users
are forbidden to access these parameters.
For the convenience of function codes setting, the function group number corresponds to the first
level menu, the function code corresponds
to the second level menu and the function code
corresponds to the third level
menu.
1.
Below is the instruction of the function lists:
The first line
"Function code": codes of function parameter group and parameters;
The second line
"Name": full name of function parameters;
The third line
"Detailed illustration of parameters": detailed illustration of the function parameters;
The fourth line
"Default value": the original factory set value of the function parameter;
The fifth line
"Modify": the modifying character of function codes (the parameters can be modified
or not and the modifying conditions), below is the instruction:
"
○
": means the set value of the parameter can be modified on stop and running state;
"
◎
": means the set value of the parameter cannot be modified on the running state;
"
●
": means the value of the parameter is the real detection value which cannot be modified.
inspection
of the modifying character of the parameters to help
users avoid inadvertent modification).
2.
"Parameter radix" is decimal (DEC), if the parameter is expressed by hex, then the parameter is
separated from each other when editing. The setting range of certain bits are 0
–
F (hex).
3.
"The default value" means the function parameter will restore to the default value during default
parameters restoring. But the detected parameter or recorded value won
’t be restored.
4.
provides
password protection to the
parameters.
After setting the password (set 07.00 to any non-zero number), the system will come into the
state of password verification firstly after the user press PRG/ESC to come into the function code
editing state. And then "0.0.0.0.0." will be displayed. Unless the user input right password, they
cannot enter into the system. For the factory setting parameter zone, it needs correct factory
password (remind that the users cannot modify the factory parameters by themselves, otherwise, if
the parameter setting is incorrect, damage to the VFD may occur). If the password protection is
unlocked, the user can modify the password freely and the VFD will work as the last setting one.
