42
Document Number
DCV-00203
Date Released
Sept. 2016
Revision Number/Security level
R03 S2
Retrofit G6+InvencoLink Wayne Vista (US) Installation Guide
Fig. 3.31
–
Two-Wire Cable connected to InvencoLink
29. Gather all loose wires (on both sides if necessary), neatly wrap them together with cable-ties and
secure to the chassis.
30.
Carefully close each Side pump door, making sure the no cables are pinched, and both the bolts
on each door are properly fastened using the special Wayne Security Key.
4.3.1 Wiring Completion
When all the cables have been installed, use cable ties to provide strain relief. The rear of the G6 OPT
has plastic loops close to the connectors that are intended to assist with this.
Also ensure that all cables are tidy and cannot become snagged or pinched when the door of the cabinet
is opened and closed.
WARNING
– Local regulations may also require that the installation is electrically tested and
certified BEFORE switch-on.
EK0127
