Installing the Footboard
WARNING!
–
Pinch point may occur when rotating the footboard
assembly.
1.
Position the footboard onto the footboard support so that the
mounting holes in the wheelchair frame align with the desired
mounting holes in the footboard support.
2.
Using the socket heat screw, three washers, spacer and locknut
secure the footboard to the footboard support.
Adjusting the Footboard Height
1.
Remove the footboard. Refer to Removing the Footboard.
2.
Adjust the footboard to one of two mounting holes in the
footboard support to adjust the footboard height by 1 inch.
3.
Install the footboard. Refer to Installing the footboard
8.15
Adjusting the Footboard Angle
1.
Loosen the jam nut
A
and set screw
B
located underneath on
the rear of the footplate
C
.
2.
Adjust the mounting screw in or out to obtain the desired
footboard angle.
3.
Thread the jam nut inward until it is flush with the footboard
bracket.
4.
Securely tighten the jam nut and washer to secure the mounting
screw in place.
1143190-N-03
71
