Invacare Storm 4 Series, Руководство по обслуживанию

Страница: 12 / 102

Invacare® Storm⁴ Series
Adjusting seat height manually with an adapter
1. Remove seat. See 4.5.1 Adjusting seat tilt on a seat with a manual tilt module (till Dec. 2010), page 15 or “Replacing
seat support with electric tilt module”).
2. Place adapter (4) in seat support (3) from below.
3. Fix adapter with two screws (1).
4. Replace seat support on lifter pillar (5).
CAUTION!
Risk of damage to lifter pillar
Lifter pillar can be damaged if screws are too long. The screws used may protrude by a maximum of 8.5
mm from the adapters.
– Only use screws supplied.
– Check screw length precisely if you do use other screws.
5. Apply medium-strength screw blocker system to four screws (2).
6. Insert four screws (2) and tighten them to a torque of 25 Nm.
7. Install parts in reverse order.
8. Test all functions.
4.2.3 Adjusting Seat Height on Type B Powered Lifter Column with Adapter
Fig. 4-2
CAUTION!
Risk of crushing
The seat is very heavy. Risk of injury to hands and feet.
– Use proper lifting techniques.
CAUTION!
Risk of crushing
Risk of injury caused by uncontrolled movement of mobility device.
– Turn off power supply (ON/OFF key).
– Engage drive.
12 1533060-N