1.
Locate the hoist trolley at the Ø 32 mm round recess
in the rail.
2.
Lift the hoist and push the suspension pin through the
trolley opening.
3.
Turn the hoist by 90 degrees to fix it in the trolley.
4.
Adjust the length of the emergency stop/lowering cord
to within the user’s reach.
Installing Robin® Mover
Robin® Mover is a ceiling hoist with the trolley already
attached. The trolley can therefore not be pre-installed in
the rail system.
The ceiling hoist has to be installed by a specialized dealer
or service technician.
4.4 Inserting hand control plug
1.
Slide and hold locking lever
A
away from the aperture
C
.
A gate in the aperture will open.
2.
Make sure the plug
B
is in the correct orientation with
the slot upwards (see image). Insert plug into aperture.
3.
Release lever, so that the gate closes and hold the plug
in the aperture.
Removing the hand control plug
1.
Slide and hold locking lever
A
away from the aperture
C
.
2.
Pull the plug
B
out of the aperture.
3.
Release lever.
1586745-C
13
Содержание Robin Mover
