Rea® Spirea® 4 NG
B
1.
Pull the lever
A
with one hand while supporting the
legrest with your other hand.
2.
When a suitable angle is obtained, let go of the lever
and the legrest will lock into one of seven preset
positions
B
.
The distance between the lowest part of the footrest
and the ground must be at least 40 mm.
3.12.2 Fixed legrest
Height adjustment
A
B
1.
Loosen screw
A
with an Allen key.
Don't touch the upper screw
B
.
2.
Adjust the legrest into a suitable height and the screw is
caught by one of the recesses on the legrest tube.
3.
Re-tighten the screw.
The distance between the lowest part of the footrest
and the ground must be at least 40 mm.
3.12.3 Adjusting the amputee legrest
WARNING!
Risk of tipping
There is an increased risk of tipping for amputated
users.
– Use anti-tip devices and/or re-balance
the wheelchair by moving the rearwheels
bachwards when amputee legrests are used.
Use the passive or the dual amputee rearwheel
attachment.
See section “Adjusting the rearwheels” for more informaiton.
Adjusting the height, depth and angle
C
1.
Loosen the lever
C
.
2.
Adjust to the required height, depth and or angle.
3.
Re-tighten the lever.
3.13 Adjusting the angle adjustable foot
plates
The foot plates can be adjusted both in depth and angle,
and can also be folded-up.
A
1.
Adjust the angle and the depth by loosening the screw
A
at the foot plate attachment.
Tools: 5 mm Allen key
2.
Adjust the foot plate to the correct position.
3.
Re-tighten the screw with 10 Nm.
Do not place anything on the foot plate when the
screw is loose.
3.14 Adjusting the one-piece footrest
WARNING!
Risk of trapping fingers
The fingers might get trapped between the foot
plate and the foot plate attachment.
– Be careful not to trap your fingers between the
foot plate and the foot plate attachment when
folding it down.
14
1536533-F
