3.7 Adjusting the push bar
WARNING!
Risk of injury
The push bar can loosen from the attachments
– Check that the hand wheels can be tightened
properly, the screw of the hand wheel should
barely be visible. If the push bar is in the wrong
position, the hand wheel will not be possible to
tighten properly.
WARNING!
Risk of imbalance
– Do not hang anything on the push bar, this
could cause imbalance.
Adjusting the height
A
1.
Loosen the hand wheels
A
.
2.
Adjust the handles to the required height position.
There are two available fixed positions
3.
Re-tighten the hand wheels
A
.
≤
2.5mm
>2.5mm
B
Make sure that the hand wheel for the push
handle
A
fits the hole in the tubes. If the
threaded tap of the hand wheel
B
is more than
app. 2.5 mm visible, the position is wrong.
Lower or raise the push handle to get the hand
wheel in the correct position.
Adjusting the angle
A
B
1.
Press the buttons
A
.
2.
Adjust the push bar
B
to the preferred angle.
3.
Release the buttons
A
.
Move the push bar slightly in order for the
buttons to lock into position.
3.8 Adjusting the seat depth
WARNING!
Risk of tipping
– When the seat depth is adjusted backwards,
also adjust the rear wheels backwards to
decrease the risk of tipping.
3.8.1 Adjustable seat
1.
A
Lift the seat
A
upwards in order to fold the chair slightly.
2.
C
B
Release the front part of the seat
B
from the hook
and loop strips.
3.
Adjust the depth by pulling the sides of the seat
forwards or backwards in the rails of the side tubes
C
.
Make sure that both sides are evenly adjusted.
4.
Unfold the chair again.
5.
Attach the front part of the seat to the hook and loop
strips again.
3.9 Adjusting the shape of the seat
A
B
1.
Release and pull back the upper section of the seat
cover
A
.
2.
Adjust the hook and loop strips
B
to the desired depth.
3.
Fold the seat cover back in place.
Always use a seat cushion when testing the final
shape of the seat.
1536533-F
11