Invacare Rea Focus 150, Руководство пользователя

Страница: 9 / 56

Product Overview
1. Remove the plastic ties A at the bottom of the backrest
cover.
B
2. Loosen the screws
B
on the backrest tubes .
3. Lower or raise the backrest to the desired position.
4. Re-tighten the screws B again.
• 5 mm Allen key
• A pair of scissors
Adjust the backrest upholstery in order for it to cover
the backrest as much as possible.
Secure the backrest cover with new plastic ties after
adjustment and tighten them well.
3.6.2 Biangular Backrest
A
C
1. Loosen the screws A .
2. Adjust the backrest to the desired position.
3. Re-tighten the screws A .
When the backrest is adjusted in height, the
lower hook and loop straps might need to be
adjusted.
4. If needed, fold down the hook and loop upholstery and
remove the unnecessary straps.
The bottom hook strap must be pulled through
the slot at the front of the backrest attachment
C
. It prevents the upholstery from sliding
upwards.
3.6.3 Reclining Backrest
WARNING!
Risk of tipping
Do not move the wheelchair when the backrest
is in reclined position.
– Invacare strongly recommend the use of
anti-tippers (available as an option) when the
backrest is in reclined position .
WARNING!
Risk of injury
The backrest is not secured
– The reclining backrest has two safety clamps
which will secure the backrest to the backrest
tubes. Make sure that the backrest is secured
in its position and that the safety clamps are
secured after each adjustment.
A
B
A
B
Reclining backrest without
gas spring
Reclining backrest with
gas spring
1. Release the two safety clamps A from the backrest
tubes.
B
2. Release the two top attachments B from the backrest
tubes.
C
1431580-C 9