Rea® Azalea®
1.
Place the wires
A
and
B
as shown on the picture above.
Risk of damage to the wires
– It is important that the cable for the
assistant brake
A
is placed on the inside of
the backrest tubes.
2.
Place the wire for the backrest/seat recline
B
outside of
the backrest tubes.
3.
Place both of the wires on the inside of the backrest
attachment
C
.
4.
Attach the wires to the backrest tubes
E
with the straps
D
.
Fold the slack of the wires under the seat to get
them out of the way.
CAUTION!
Risk of reduced brake effect
– The wires must not be crossed on the backrest!
5.5.2 Wires with backrest plate
A
B
1.
Thread the wires on the outside of the backrest tubes
B
.
2.
Place the wires in the holders/clips
A
in order to hold
them in place.
Fold the slack of the wires under the seat to get
them out of the way.
5.6 Folding the backrest
WARNING!
Safety risk
The wheelchair may collapse
– When the safety pin is removed, there must
not be any weight on the backrest.
A
B
C
With the help of the piston rod resting lip
A
, the therapist /
assistant can loosen the safety pin
B
for the backrest piston
rod
C
when folding, in order to avoid that the piston and
backrest falls to the ground.
WARNING!
Safety risk
The wheelchair may collapse
– Remember to always reinsert and fasten the
safety pin when it has been removed.
– Check that the lock shackle / loop is securely
locked.
See section: “Folding the backrest” for instructions on how
to secure the safety pin
B
.
5.7 Armrests
A
B
1.
Place the armrest in the armrest attachment
A
.
2.
Press the auto-lock button
B
and press the armrests
downwards until you can feel/see that the armrests are
securely in place.
The armrests have an auto-lock to prevent
involuntary movement or detachment.
3.
Press the auto-lock button
B
to release before removing
or adjusting the armrest.
5.8 Rear wheels
A
B
C
36
1488727-R
Содержание rea azalea assist
Страница 59: ...Notes...
