SECTION 5—WHEELCHAIR OPERATION
Pronto
®
M94
™
30
Part No. 1122145
NOTE: For specific information about the joystick installed on the wheelchair, refer to one (1) of
these procedures:
• SPJ-80 Joystick Switches and Indicators on page 30.
• DPJ Joystick Switches and Indicators on page 31.
• MPJ Joystick Switches and Indicators on page 33.
SPJ-80 JOYSTICK SWITCHES AND INDICATORS
NOTE: Refer to FIGURE 5.2 for the following information.
NOTE: The SPJ-80 joystick must be used with the MK5 NX
™
-80 (80 amp) controller.
FIGURE 5.2 - SPJ-80 JOYSTICK SWITCHES AND INDICATORS
ON/OFF TOGGLE SWITCH
This toggle switch is located at the back of the joystick housing.
SPEED CONTROL SWITCH
The speed control switch is located on the back of the joystick housing. This rotary switch
is used for controlling the speed and acceleration of the wheelchair.
1. Turn the switch CLOCKWISE to increase the speed of the wheelchair.
2. Turn the switch COUNTERCLOCKWISE to decrease the speed of the wheelchair.
JOYSTICK
The joystick provides proportional drive control of speed and direction.
BATTERY GAUGE DISPLAY
Located at the rear of the joystick housing, it provides information on the remaining
charge in the batteries. At full charge, all six (6) segments of the bar graph are lit. The
lower the battery charge the fewer number of segments light up. Once the the battery
level reaches the point where only one segment is lit, the last RED bar will start to flash
on and off to indicate that the user should charge the batteries as soon as possible.
Joystick
Speed Control Switch
On/Off Toggle
Switch
To Controller
Charger/
Programming Input
