Invacare Motion Concepts MaTRx Seating Series, Руководство по установке

Страница: 1 / 20

Swing-Away Lateral Installation Instructions:
MaTRx-PB Elite
MaTRx-PB Elite
1 Pull up the bottom of the cover (release velcro fasteners) to expose the mounting slots/channels in the back pan.
2 Determine the desired mounting height/orientation for the lateral pads (upper or lower mounting slot position).
3 Loosely install the lateral supports onto the back pan using the hardware provided. (Note: the backing plate is
installed from the inside of the back pan through the lateral support brackets and secured to the back pan via
the washer plates and locking nuts - refer to
Figure 1.0 below.
4 Adjust laterals to the desired position via the mounting slots on the backpan and via the slots in the lateral sup-
port bracket. Secure each lateral support into place.
5 Re-attach the back cover via the velcro fasteners.
Instructions for Installing Standard and Offset Swing-Away Lateral Supports:
Standard Lateral
Support Bracket
Figure 1.0 Figure 1.0
Swing-Away Lateral Installation & Adjustment:
Swing-Away Lateral Installation & Adjustment:
vertical
adjustment y
3” (76
mm
)
TRD0277-04
Offset Lateral
Support Bracket
Lower
Mounting
Slots
1
Upper
Mounting
Slots
horizontal adjustment
1 Note:
lower mounting slots are
not
available on
12” (31cm) high Matrx-PB Elite backs
3” (76
mm
)
REAR VIEW
FRONT VIEW
Standard
Swing-Away
Lateral
Offset
Swing-Away
Lateral
Inverted
Position
*Note: offset swing-away laterals may also be mounted in the
inverted position (as shown) to provide extended support
EN
- 1 -