Invacare AVIVA RX40, Руководство по обслуживанию

Страница: 24 / 44

Invacare® Modulite
Removing H-belt
1. Remove protective cap B .
2. Loosen and remove screw F , associated washers E
and nuts D (in front of the/behind the gripper clamp
C ) with a 5 mm Allen key and a 13 mm socket wrench.
3. Loosen and remove screw
J
, associated washer
I
,
stopper H , belt winder G in the lower part of the
H-belt
A
with a 5 mm Allen key.
A belt winder is installed, so that the belt bracket
can move freely.
4. Replace H-belt
A
.
Installing H-belt
1. Install parts in reverse order.
5.6.5 Replacing H-belt (backrest frame)
Note:
• 13 mm socket wrench
• 5 mm Allen key
Removing H-belt
1. Remove protective cap (2).
2. Loosen and remove screw (6), associated washers
(5) and nuts (4) (in front of the/behind the gripper
clamp (3)) with a 5 mm Allen key and a 13 mm socket
wrench.
3. Remove protective cap (9).
4. Loosen and remove screw (8), associated washers (7)
and nuts in the lower part of the harness belt (1) with
a 5 mm Allen key and a 13 mm socket wrench.
Another nut is installed between washers as
a spacer, so that the belt bracket can move
freely.
5. Replace harness belt (1).
Installing H-belt
1. Install parts in reverse order.
5.7 Replacing armrests and upper body
support options
For armrests and upper body support options, see 5.3.4
Armrest styles, page 16 and 5.3.6 Support options, page 18 .
5.7.1 Removing/ Installing armrest
This chapter applies for armrests on the telescopic
seat frame.
Tools:
• 8 mm Allen key
1. If necessary, disconnect joystick.
2. Loosen Allen screw (1) with an 8 mm Allen key.
3. Pull armrest (2) out of mounting bracket.
4. If necessary, replace armrest including mounting
bracket.
5. Install parts in reverse order.
5.7.2 Removing/Installing armrest
This chapter applies for armrests on the one piece
seat plate.
24 1604311-G