Installing backrest unit
1.
Install parts in reverse order.
2.
To conclude, carry out a trial run to test vehicle
functions.
5.4.2 Replacing Flex3 tension adjustable
backrest
Tools:
•
5 mm Allen key
•
6 mm Allen key
Push handles are on hinges, fastened from below with
two screws.
Removing
1.
Loosen screws.
2.
Take off backrest from hinges of the seat.
3.
Loosen four screws
C
and take off upper traverse
B
from push handles
A
.
4.
Loosen four screws on four clamps
C
.
5.
Turn clamps to vertical position.
6.
Take off back.
7.
Remove seat cover.
Installing
1.
Install parts in reverse order.
2.
Tighten screws.
5.4.3 Replacing Backrest Mounting Bracket
•
6 mm Allen key
The mounting brackets for the Flex3 backrest and a
seat width of 530 mm are inrigged. The course of
action is the same.
Removing Bracket
Fig. 5-1
1.
Remove backrest cushion.
2.
Loosen fixation of corresponding backrest posts (1),
depending on version. There are two versions of
fixations:
•
(2) Fixation lever: for manual backrest
•
(3) Screw: for powered backrest
3.
Remove backrest posts.
4.
Loosen and remove two screws (4) to T-nut (5) on
both sides.
Installing Bracket
1.
Install parts in reverse order.
2.
Test all functions.
5.4.4 Replacing bag hooks
•
6 mm Allen key
Removing
1.
Remove screws
A
.
2.
Remove bag hooks
D
,
C
and the distance spacers
from backrest
B
.
Installing
1.
Install parts in reverse order.
2.
Tighten screws to 22 Nm.
1604311-G
21
Содержание AVIVA RX40
Страница 13: ...Setup 4 Insert four screws A 5 Tighten four screws 1604311 G 13...
Страница 43: ...Notes...
