CAUTION!
Risk of Damage
Exposure to liquids may damage components or
accessories of wheelchair and electronics.
–
DO NOT spray with any type of water or liquid.
–
Electrical components damaged by corrosion MUST
be replaced immediately.
WARNING!
Risk of Injury, Damage or Death
Excessive moisture or cleaning may reduce the flame
retardancy of the upholstery and may result in injury,
damage or death.
–
Follow all cleaning instructions.
–
Avoid excessive moisture or cleaning.
Regular cleaning will reveal loose or worn parts and enhance
the smooth operation of your wheelchair. To operate
properly and safely, your wheelchair must be cared for just
like any other vehicle.
For upholstery that is severely stained or surface finish that
is badly damaged, contact Invacare for further information.
1.
Use the following instructions to clean this product unless
otherwise specified.
•
Upholstery — Warm water and mild non-abrasive soap.
•
Metal — Hot water and mild non-abrasive soap. Car polish
and soft wax may be used to remove abrasions and restore
gloss.
•
Plastic — Hot water and mild non-abrasive soap.
2.
Dry the surface with dry cloth.
3.
DO NOT use solvents or kitchen cleaners.
7.7
Installing/Removing 70A°
1.
Turn the footrest
A
to the side (open footplate is perpendicular
to wheelchair).
2.
Install the hinge plates
B
on the footrest onto the hinge pins
C
on the wheelchair frame.
3.
Push the footrest towards the inside of the wheelchair until it
locks into place.
The footplate will be on the inside of the wheelchair
when locked in place.
4.
Repeat STEPS 1-3 for other footrest assembly.
5.
To remove the footrest, push the footrest release lever
D
inward, rotate footrest outward.
6.
Adjust footrest height, if desired. Refer to 7.19 Footrest Height
Adjustment, page 43.
1143192-L-03
35
