Invacare® Action® Ampla™
1.
Insert the drip stand rod
A
with its screw element
B
through the lock washer
C
and washer
D
into the
required hole of the drip stand support
E
.
2.
Secure the drip stand assembly to the drip stand
support using the washer
F
and handle
G
by turning
it clockwise.
3.
Loosen the clamping parts
I
and
M
by turning the
levers
H
and
N
counterclockwise.
4.
Remove the push bar
L
.
5.
Position the clamping part
K
on the frame tube
J
.
6.
Position the drip stand support
E
on the clamping part
K
.
7.
Position the clamping part
I
on the drip stand support.
8.
Insert the push bar through the parts
I
,
E
and
K
into
the frame tube (only through clamping part
M
on the
other side).
9.
Insert and secure the lever
N
in one of the two lower
holes
O
on the push bar.
10. Secure the push bar by turning the lever
H
clockwise.
Adjusting the Height and Angle
The rod of the drip stand must always be placed in a
vertical position, i.e. in a 90° angle to the ground, no
matter the position of the backrest or the wheelchair.
1.
Loosen the lever
A
.
2.
Adjust the drip stand
B
to the desired height and
correct the angle for vertical alignment (90° angle to
the ground).
3.
Re-tighten the lever
A
.
6.7.5 Installing the cane holder
The cane holder can be installed either on the left or on the right rear side of the wheelchair.
Allen key (4 mm, 5 mm)
■■□
26
1650187-A
