Intrinsyc Open-Q 605, Руководство пользователя

Страница: 26 / 52

Intrinsyc Open- Q™ 605 SBC User Guide and HW Specification V. 1.4
26
Copyright Intrinsyc Technologies Corporation
3.11 Expansion Connector (J3600)
Figure 11: 76-Pins expansion connector (J3600)
This section describes the signals available on the SBC’s Expansion Connector (J3600). Pin out
information is provided below for reference. Note that the SBC schematic is the controlling
document and is available to customers who have purchased the platform and registered it on the
Intrinsyc Support site. In the event of pin-out difference(s) between this document and the SBC
schematic, the SBC schematic shall take precedence. All signals are 1.8V tolerance except noted
specifically.
Table 3-12 – Open-Q™ 605 SBC expansion connector J3600 pin out
Pin Signal Pin Signal
1 CBL_PWR_N 2 VREG_L14A_1P8
3 PHONE_ON_N 4 CDC_HPH_L
5 KEY_VOLP_N 6 CDC_HPH_REF
7 GND 8 CDC_HPH_R
9 PM_RESIN_N 10 CDC_MIC_IN3
11 GP92_FOCUS_N 12 PM670_AMUX_3
13 GP91_SNAPSHOT_N 14 CDC_GND_CFILT
15 GND 16 SPK_P
17 CDC_HS_DET 18 SPK_N
19 GP2_QUP0_L2 20 CDC_MIC_IN2
21 GP0_QUP0_L0 22 CDC_MIC_BIAS1
23 GND 24 VPH_PWR
25 GND 26 VPH_PWR
27 GP43_QUP3_L2 28 GP3_QUP0_L3
29 GP42_QUP3_L1 30 GP1_QUP0_L1
31 LPI_QUP4_DBG_RX 32 GP44_QUP3_L3
33 LPI_QUP4_DBG_TX 34 GP41_QUP3_L0
35 APQ_GP118 36 LED_RGB_RED
37 APQ_GP117 38 LED_RGB_BLUE
39 PML_GP6_LPG_PWM 40 LED_RGB_GRN
41 APQ_GP120 42 FLASH_LED2
43 GND 44 FLASH_LED1
45 LPI_MI2S_2_SCK 46 FLASH_LED3
47 LPI_MI2S_2_WS 48 VCOIN
49 LPI_MI2S_2_DATA1 50 HAP_OUT_P
51 LPI_MI2S_2_DATA0 52 HAP_OUT_N