Intralox ThermoDrive, Инструкция по эксплуатации

Страница: 64 / 78

11 SPECIAL PROCEDURES
Belt Splicing System v.2.0
11-3
Trim the Second Weld Bead—
Alternative Technique
If working alone or with low clearance, con-
sider this alternative technique for removing
the second weld bead from the belt splice.
1. After the first weld bead is removed, leave
the Clamping Fixture in place.
2. Place the Cut Guide rail between the
Grooved Decks, and bend the belt back so it
lies on the flat Cut Guide base.
Figure 11F: Bend belt back onto Cut Guide
3. Use Trimmers to cut a small piece of the
weld bead from the belt at the belt edge.
4. Place the Skiver blade under the cut weld
bead and trim the weld bead from the belt.
5. To finish trimming and inspecting the belt,
see Trim Belt Edges on page 7-2.
Inspect the Clamping Fixture
Ensure the Clamping Fixture meets the follow-
ing requirements before aligning belt ends.

The Clamping Fixture Grooved Decks
open smoothly when the Crank Handle is
turned counter-clockwise.
Figure 11G: Open Clamping Fixture

The Clamping Fixture closes smoothly
when the Crank Handle is turned clock-
wise, then locks closed at the “click.”

Ensure the pads on each end of the
Clamping Fixture touch. Middle Clamp-
ing Fixture pads do not have to touch.
Figure 11H: Close Clamping Fixture and ensure
metal pads touch