WiBAS OSDR-Hub & Terminal Station / WiBAS-Connect Terminal Station
Start Up & Commissioning Manual - Edition 5.1
71
WiBAS-Connect TS (Auto-Polarization Edition)
,
Continued
Procedure for
WiBAS-
Connect Auto-
Polarization TS
with Parabolic
Low Profile
Antenna
To perform WiBAS
TM
-Connect
auto-polarization
radio unit TS parabolic low
profile antenna alignment, please follow the steps below:
This procedure is performed for Auto-Polarization Edition radio unit.
The factory default polarization for dual polarization terminals is V.
It is assumed that WiBAS-Connect TS has dual frequencies configured.
The TS polarity is identified via voltmeter value, as follows:
•
In
vertical polarity
the voltmeter shows
0.X
, where X is the QI value.
•
In
horizontal polarity
the voltmeter shows
1.X
, where X is the QI
value.
•
During
polarity change
the voltmeter shows
~2.5 V
and no action
should be performed.
For QI values please refer to
on page
Continued on next page
