INTORQ 14.105 Series, Руководство по эксплуатации

Страница: 21 / 24

Maintenance 6
i
j
| BA 14.0175−EN | 11/2007
21
6 Maintenance
The INTORQ clutches and brakes are largely free of maintenance. In applications requiring
many switching operations the air gap s
air
" must be checked and readjusted at certain
periods. When the air gap has reached 250 % of its rated value s
air
" it must be readjusted
to the rated value at the latest.
| For air gap setting s
air
" after wear, see chapter 6.1, Dismounting.
| The shims mentioned in section 2 can be removed or the spacers can be reduced.
The friction face poles of the rotor or stator of clutches or brakes run into the armature
plate. Friction marks are thus normal and must not be re−worked!
(
Stop!
Friction faces must be kept absolutely free of oil and grease!
6.1 Dismounting
Remove the axial circlip or shaft locking plate Fig. 7 to disassemble the armature assembly
of design 1 or 2 or the rotor. After that the armature assembly can be withdrawn from the
shaft via the withdrawal thread d" (see Fig. 7 and Tab. 3) provided for disassembly in the
flange hub or rotor of the corresponding part. After the armature assembly has been
withdrawn, remove the shims depending on the air gap size s
air
" (Fig. 5 and Tab. 1) and
mount them afterwards between circlip and flange hub.
d
e
d
c
Shims
1
Fig. 7
Dimensions Size
06 08 10 12 16 20 25
c 29 36 46 56 73 92 114
e 31 37 47 56 73 93 120
d M4 M4 M4 M4 M5 M6 M8
d1 M5 M5 M5 M6 M8 M8 M10
Tab. 3 Dimensions in mm