295
A
S AVE THESE INSTRUCTIONS
(295IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 11/06/2017
English
Page 10
SET UP (continued)
5.
Press the button to turn on the control unit panel
buttons
fi
rst. Press the button to in
fl
ate the
spa tub wall for 8 to 10 minutes until it is
fi
rm to the touch
but not hard
(see drawing 6)
.
IMPORTANT:
Do not over in
fl
ate or use high pressure air
compressor to in
fl
ate.
6.
Press the button again to turn it off.
7.
Replace the air valve cap back.
NOTE:
The cap is designed to be screwed on and off.
Never exert force as this could cause the complete
internal in
fl
ation system of the valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
Infl ate the Spa Cover Air Bladder
1.
Open the in
fl
ation valve and insert the in
fl
ation
hose
(7)
into the valve; press to in
fl
ate
until it is
fi
rm to the touch but not hard
(see
drawing
7)
.
2.
Disconnect the in
fl
ation hose
(7)
from the air
blower
in
fl
ation outlet and the valve.
3.
Replace the control base in
fl
ation cap
(5)
back; close and recess the in
fl
ation valve.
NOTE:
If there is a need to add some air to the spa tub wall or spa cover air bladder after they have been
setup, refer to above “In
fl
ate the Spa Tub Wall” and “In
fl
ate the Spa Cover Air Bladder” sections. The cover
air bladder is preinstalled inside the spa cover. If it needs to be reinstalled, place the unin
fl
ated air bladder
inside the spa cover lip before in
fl
ating the bladder.
Defl ation
For Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem in
and turn 90 degree right to secure it in the down
position
(see drawing 8)
.
2.
Once the de
fl
ation is completed, push the stem in and
turn 90 degree left to return it to the in
fl
ation position.
3.
Replace the cap back.
For Cover Air Bladder:
1.
Pull valve cap out and squeeze the valve at its base until
de
fl
ated.
2.
Close and recess the valve back.
7
7
6
8