(174IO) DELUXE POOL MAINTENANCE KIT ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/30/2013
174A
S AVE THESE INSTRUCTIONS
English
Page 8
SETUP INSTRUCTIONS (continued)
12
Turn on the pump. To eliminate air trapped in the hose or in the pump system, turn
the air release valve (if any) 1-2 turns to allow air to escape. Refer to the pump
owner’s manual for details.
IMPORTANT:
Never run the pump dry as the motor may
overheat and damage the pump. Keep the vacuum body under the water at all times
during use, or the air will come into the hose, causing the pump to run dry and
damaging the pump.
13
If the debris bag
(4)
is full and experiencing low suction when vacuuming, turn off the
pump and bring the vacuum body assembly out of the water. Empty the debris bag by
reversing steps 1 to 3. Make sure the debris bag and vacuum body are clean before
replacing the components back. Repeat steps 1 to 3 to replace all components back.
NOTE:
if experiencing low suction and the debris bag is clean, make sure the pump is
running, there is no blockage and/or air trapped along the water
circulation line.
• Release all the air from the hoses and filter pump before use.
• Keep the vacuum body under the water at all times during use.
• Remove the vacuum body assembly, hose and adaptor, and replace the strainer grid when
running the filter pump only and when the pool is not in use.
• Check and empty the debris bag regularly during and after each use.
IMPORTANT
The pool vacuum is now ready to use.
