inTest THERMOSTREAM ATS-515, Интерфейс и руководство по приложениям

Страница: 66 / 116

4
R E M O T E I N T E R F A C E S
Device Specific Commands
4-14 ATS-515, -525 & ATS-615 & -625 Interface & Applications Manual
Device Specific Commands
Command Description
ADMD Set the air-to-DUT maximum difference.
ADMD nnn -- where nnn is 10 - 300 °C in 1 degree increments.
ADMD? Read the air-to-DUT maximum difference.
AMPS? Read the system’s current draw (amperage).
AUXC? Read the auxiliary condition register.
bit 10 – reserved
bit 9 – ramp mode
bit 8 – Manual Mode= 1, Program= 0
bit 7 – reserved
bit 6 – ready for operation = 1, startup sequence = 0
bit 5 – flow on = 1, flow off = 0
bit 4 – DUT mode = 1, air-control mode = 0
bit 3 – heat only mode =1, compressor on =0
bit 2 – head up = 1, head down = 0
bit 1 – reserved
bit 0 – reserved
CFIL Copy active setup file (0) to setup n (1 - 12).
Use the CFIL command to save your current setup file.
CLER Clear device-specific (reported by EROR?) errors.
NOTE : After sending this command, wait 4 seconds before sending
another command.
COOL Turn the compressor on or off.
COOL 1 – turn the compressor on
COOL 0 – turn the compressor off
NOTE : There is a 60 second delay between the time that the
compressor is turned on and the System is ready to operate.
COOL? Read COOL on/off state. 1 = compressor on, 0 = compressor off.
CYCC Set the cycle count.
CYCC nnnn -- where nnnn is the number (1 - 9999) of cycles to do.
CYCC? Read the number of cycles to do.
CYCL Start/stop cycling.
CYCL 1 – start
CYCL 0 – stop
NOTE : When all cycles have been completed or when cycling was
stopped on failure, it is necessary to send a CYCL 0 command to
reset the system.
CYCL? Read the cycle number (current value if cycling, last value if not).
NOTE : If Version 1 compatibility mode is enabled, CYCL? returns
the number of fully completed cycles.