IntesisBox MH-RC-WMP-1
Installation Manual
Doc. Rev.1.0
La información en este documento puede variar sin previo aviso.
URL
tel
http://www.intesisbox.com
[email protected]
+34 938047134
This information is subject to change without notice.
© Intesis Software S.L.U. - Todos los derechos reservados/ All rights reserved
IntesisBox es una marca registrada de / is a registred trademark of
Intesis Software SL
WARNING
Follow carefully this safety and installation instructions. Improper work may lead to serious harmful for your health and also may
damage seriously the interface and/or the AC indoor unit.
• This interface must be installed by accredited technical personnel (electrician, installer or authorized technical personnel) and
following all the safety instructions.
• This interface must only be installed in a restricted access location.
• Before manipulate the AC indoor unit be sure it is completely disconnected from Mains power.
• In case of installation of the interface inside the AC indoor unit, fix the interface and communication cables preferably to any
appropriate point of the plastic cover of the unit taking care of no blocking free movement of mobile parts and as far as possible
from tubes containing liquids and power cables.
1. Unplug the Air Conditioner (AC) unit from the power supply line.
2. Access to the main Printed Circuit Board. *
3. Locate the socket connector marked as X/Y. *
4. Select a location for the IntesisBox device.
5. Connect the Air Conditioner X/Y connector with the IntesisBox X/Y connector. **
6. Connect the external antenna into the antenna connector. Make sure you screw the antenna connector
in a clockwise direction until it stops.
7. Place the antenna outside the AC, preferably in a vertical position and pointing directly to the Wi-Fi Router or Access Point.
8. Close the Air Conditioner unit.
9. Plug the AC to the power supply line. If connection with the Air Conditioner has been successful, IntesisBox device LED will
start blinking Green and then will change to steady Green.
* See Mitsubishi Heavy Industries installation or service manual for detailed information.
** The cable used for the MH-RC-KNX-1i to X/Y connection bus can be any two-wire cable; the maximum distance for bus X/Y is 600 meters; check the AC indoor unit
user’s manual for more details.
IMPORTANT: Use only the cable attached. Extending or shortening the connecting cable included with the interface may
cause it to malfunction. Keep the connecting cable as far away as possible from electrical wires and ground wire. Do not
bundle them together.
NOTE: It is not mandatory to have a wired remote controller in the X/Y bus, but if available it is recommended to have it
configured always as Master, and there cannot be any other remote controller in the network.
Safety instructions
Installation instructions
DIP-SW4 – ON (
): MHI RC is not present
DIP-SW4 – OFF (
): MHI RC is present
1. IntesisBox device
2. External antenna
3. Wi-Fi Access Point or Router
4. MHI Indoor Unit with XY connector
5. DIP-Switch
6. Remote controller