www.intertec.info
Operating Instructions Filter ventilator FL-ExVENT
COM155769227Ien-4
Page 7 / 8
INTERTEC-Hess GmbH · Raffineriestr. 8 · 93333 Neustadt/Donau · Germany ·
+49 9445 9532-0 · [email protected]
•
Pump clean air:
If the air is very dusty, you must use a filter upstream
•
Distance between rotating elements:
The distance of the rotating elements in the axial and
radial direction must not be less than 2 mm from the
fan housing.
11
Deinstallation
Disassembly may only be carried out by a trained
person.
DANGER
Risk of fatal injury from electric current!
If contact is made with live components, there is the risk
of fatal injury.
For this reason, switch off the voltage supply, secure
against being switched on again and check that no more
voltage is present.
Disconnect connection line from the clamps and from the
connection socket, disconnect device from bracket and
remove it.
12
Disposal
Disassemble the components of the product, taking the
applicable local labour protection and environmental
regulations into consideration and make sure that the
components are recycled:
• Scrap metal
• Send plastic elements to recycling
• Sort other components according to their material
properties and dispose of them.
NOTICE
Environmental damage may be caused if
disposed of incorrectly!
Electrical scrap and electronics components are subject
to hazardous waste treatment and must only be
disposed of by certified specialists!
The local community authorities or specialist waste
disposal companies can provide information on
environmentally friendly disposal.
13
EU declaration of conformity
The
manufacturer,
INTERTEC-Hess
GmbH,
Raffineriestrasse 8, 93333 Neustadt/Donau, Germany,
hereby declares in sole responsibility that the product
Product / Type designation:
FL-ExVENT
complies with the provisions of the following directives
2014/34/EU (ATEX), 2014/30/EU (EMC), 2011/65/EU
(RoHS), 2012/19/EU (WEEE) complies with the following
standards, harmonized standards, where appropriate
and/or standardized documents:
EN 60079-0:2012+A11:2013
EN 60079-18: 2015
EN ISO 80079-36:2016
EN ISO 80079-37:2016
EN 14986:2017
Harmonized Standard (RoHS):
DIN EN IEC 63000:2019
Designation:
2572
II 2 G Ex h mb IIB+H2 T4 Gb
PTZ 18 ATEX 0050 X
Neustadt, August 18th, 2021
Dipl.-Ing. Martin Hess, Managing Director
14
Further information and service
If the information contained in this instruction manual
should not be sufficient in any way, then INTERTEC
would be glad to be at your disposal to provide further
information and service.
Please contact your INTERTEC contact person or
directly contact
INTERTEC-Hess GmbH
Raffineriestr. 8
93333 Neustadt/Donau
