KNX IP Router
Product Manual
18
@2019 INTERRA
PM190205012AEN
4.2) IP Configuration
After an ETS download IP addresses are not updated. It is essential to execute a manual device restart(bus disconnection,
reset of the line) to get IP configuration data updated.
Fig 6 : IP Configuration Tab Parameters
4.2.1) Parameters List
PARAMETER
DESCRIPTION
VALUES
HTTP Port
Select one of the two official system ports.
80
8080
DHCP
If DHCP is used, no further IP parameters have to
be set.
do not use
use
IP address*¹
Due to each part is 1 byte, the values should be
adjusted by entering between 0 and 255.
0-255.0-255.0-255.0-255
[0.0.0.0]
Subnet mask*¹
Due to each part is 1 byte, the values should be
adjusted by entering between 0 and 255.
0-255.0-255.0-255.0-255
[0.0.0.0]
Default gateway*¹
Due to each part is 1 byte, the values should be
adjusted by entering between 0 and 255.
0-255.0-255.0-255.0-255
[0.0.0.0]
DNS server*¹
Due to each part is 1 byte, the values should be
adjusted by entering between 0 and 255.
0-255.0-255.0-255.0-255
[0.0.0.0]
*¹
This parameter, is only visible when the
“
DHCP
”
parameter is set to
“do not use”
.
