Interphase ENTIA 5536 DM PRI, Руководство пользователя

Страница: 65 / 244

Chapter 4: Installing the Software
5536 PRI RAS Communications Controller Users Guide
45
This dialog box enables you to set up 5536 firmware and
hardware. The board name is displayed in the Cards section.
N
OTE
If the Cards list is empty, the board might not be properly
installed. See
Problems and Possible Solutions on page
123 for information about correcting the problem.
Use the Cards section to do the following tasks:
• If your board is connected to an MVIP Bus, enable the
MVIP bus connection.
• Set up ISDN port properties.
Configure ISDN port properties for both ISDN and
Digital Modem RAS Support drivers.
• If you plan to install the Digital Modem RAS Support
driver, set up digital modem port properties. Set up
digital modem and ISDN port properties at this point
(regardless of which driver you selected first).
Enabling the MVIP Bus Connection
If your board is connected to an MVIP Bus, enable the Bus
connection as follows:
1. In the Cards section of the WAN Adapters Setup dialog
box, select the board and click the
Properties button.