Interpack CE-12P, Руководство по эксплуатации и список запасных частей

Страница: 6 / 43

CE-12P Manual 6
USM8131
4 MACHINE INSTALLATION
Open the package and unpack the machine carefully for the installation. Please
check if the machine has any visible damage occurred during shipping, If any damages
have occurred during shipping, be sure to advise the shipping carrier and your
distributor.
Remove the fixed items inside the machine related to shipping (Ex: wooden block,
plastic band). Install the CE12P to the desire location where 110 AC power and
compressed air is available within reach of the
machine. Connect power, compressed air and
adjust pressure to 80 psi, and then open manual
valve located near the exit of the CE-12P (Figure
4.1).
After installation, adjust the height of working
table to parallel with the height of your production
line or conveyor. To test the machine for proper
functioning switch on the main breaker switch
located below the Control Panel. On the selector
switch select manual mode and clear any fault
conditions. Press the “Function ON” button on the
control panel to activate each manual function
step (see table 4.1 for manual function codes; also located on the machine control
panel).
As you go through the manual function codes you should experience some activity
associated with each manual cycle step. When fault message display’s 01, side belts
should turn on. Next, manual code 02 activates vacuum, code 03 movea vacuum cups
forward, code 04 moves vacuum cups back to the
original home position,
and code 05 turns on the guide cylinder.
Consequently, code 06 moves the front minor flap
folding up, code 07 moves rear minor flap folding up,
code 08 left major flap folding as code 09 right major
flap folding move up. Finally, code 10 releases
vacuum and last code 11 pushing cylinder activates.
The “Function OFF” button turns off each code in
reverse order or just turn on a particular function
code and turn off to observed the on and off cycle.
Once the machine manual steps function properly,
follow section 5 “Operating Instructions” for the
proper operation and set-up of your CE-12P Case
Erector.
Figure 4.1
Manual Function Codes
01 Side Belt On
02 Vacuum Activated
03 Vacuum Cup Forward
04 Vacuum Cup Backward
05 Guide Cylinder
06 Front Minor Flap Folding
Up
07 Rear Minor Flap Folding
Up
08 Left Major Flap Folding Up
09 Right Major Flap Folding
Up
10 Vacuum Released
11 Pushing Cylinder
Table 4.1