Internet Security Systems Proventia A1204, Руководство пользователя

Страница: 28 / 42

Chapter 2: Configuring and Viewing Appliance Settings
20
Changing the Port ID Value
Introduction
The Proventia A604, A1204, and A1204F appliances can identify the specific port that
detected an event. This enables you to identify the affected network segment. Identifying
the port and network segment aids forensic investigation when up to four unrelated
segments are monitored on one appliance.
Where configured
You change the port ID value on the SiteProtector management console.
Port and adapter
names
Four ports on the back of the appliance, labeled A, B, C, and D, correspond to a parameter
setting for an adapter that is enabled on the management console. The corresponding
settings are adapter.A.name, adapter.B.name, adapter.C.name, and adapter.D.name.
Events detected by the adapter for a port appear in the Event Details window.
Parameters
settings for
adapters
The parameter settings for the adapters are enabled by default in the management
console. Under most circumstances, you do not need to change these parameters.
However, you may want to customize the parameters if you change the name of the
adapter or change the segment that the adapter is monitoring.
Changing the port
ID value
Open the SiteProtector management console. Use the Advanced Parameters tab on the
Sensor Properties window to view or change the port ID value.
To change the port ID value:
1. In the SiteManager grouping tree, select the group to which the appliance is assigned,
and then select the Sensor tab in the right pane.
A list of sensors and appliances appears.
2. Right-click the appliance, and then select Network Sensor .
3. Select Edit Properties .
The Sensor Properties window appears.
4. In the Sensor Properties window, select the Advanced Parameters tab.
5. Select the adapter name, and then click Edit .
The Advanced Value window appears.
6. Change the adapter value for the port ID, and then click OK .
Example:
You may want to change the adapter to correspond to a segment. For
example, the value A could change to Marketing Segment 3 .
7. Repeat Steps 5 and 6 for each adapter name you want to change.
8. Click OK .
The Sensor Properties window appears.