Section 7, Plumbing the System
7-6
The Oasis
®
Chinook Heating System
Figure 7-3: Three Approved Methods of Installing Heater Hose
(consult ITR for alternative methods and products)
7.5 Potable Water Plumbing Installation
The Potable water connections are located on top of the Oasis
®
Chinook-S. The Cold water supply and Hot water outlet can be
connected using ½” NPT to PEX crimp fittings.
The maximum water supply pressure to the heater is 150 PSI (10
bar). The Hot water Outlet temperature is regulated by an internal
mixing valve factory set at 120F (49°C). If needed this valve can be
adjusted between a range of 95F (35°C) to a maximum of 145F
(63°C). See Figure 7-4: Potable Hot water system plumbing.
All fittings, hose, tube and fitting sealant involving the potable water
must be food safe and approved for use with potable water and
rated for the potable water system pressure.
WARNING
