Page 4
HOW TO INSTALL SEA BREEZE TTW IN EXISTING SLEEVE
1.
Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
·
Clean interior but do not disturb seals.
·
Wall sleeve must be securely fastened in wall before installing air conditioner.
2.
Drill a
3/16” clearance hole for grounding screw through left side of
wall sleeve, about 3 inches (maximum) from the front edge of
sleeve as shown. Next attach ground wire inside sleeve, using
grounding screw and nut. Pull end of ground wire out the front of
the sleeve, and temporarily bend it down and around lower edge of
sleeve.
3.
Prepare the wall sleeve for installation of new unit. For existing wall
sleeve and rear grille, see
Option 1
below.
NOTE:
Wall sleeve (4230050) is not shipped with TTW
and must be purchased separately.
4.
Install unit into wall sleeve.
5.
Attach ground wire to the new unit by removing the screw from the left side front.
6.
Assemble and install the trim frame. See
“
Finish
Installation
” page 6.
IMPORTANT NOTES:
·
The unit is equipped with a rubber grommet mounted compressor. These grommets are factory set and require no
adjustment.
·
Check for obstruction to air flow, correct if necessary. The unit must be located where curtains, furniture, trees, or
other objects do not block air flow to and from the unit. If air is obstructed and/or deflected back into the unit, the
air conditioners compressor may cycle on and off rapidly, this could cause damage to the compressor.
OPTION 1
–
Using existing sleeve and rear grille.
If there is an existing sleeve and grille, the louvers will have to be bent as per the instructions in Fig. 1 below. If this is
too hard to accomplish, refer to
OPTION 2
.
NOTE:
Do not remove the seals from the existing grille.
OPTION 2
–
Use the grille packed with your air conditioner.
1.
Remove existing grille and secured as necessary.
2.
Place the included aluminum grille towards the rear of unit.
3.
Mark through the hole positions.
4.
Drill through the sleeves flanges with a 1/8
” drill bit.
5.
Attach the new grille with self-threading screws and washers
(not included).
NOTE:
It is very IMPORTANT that the grille is placed exactly as shown below.
6.
Attach (1) 1
” x 3/8” x 25” long seal in the center at the top of the sleeve. Remove the backing paper and press into
position.
3”
Fig. 1
