- 10 -
REMOVING THE COLLECTED WATER
There are three ways to remove the collected water.
USING THE BUCKET
1. The Full Light
will illuminate indicating that bucket is full.
If the unit is on and the bucket is full, the unit will automatically turn off and the
Display will show the error code “P2”.
2. Slowly pull out the bucket.
3. Grip the left and right handles securely and carefully pull out straight so water does
not spill.
Do not put the bucket on the floor because the bottom of the bucket is uneven.
4. Discard the water.
5. Place the bucket back into the unit. The bucket must be in the proper position for the
dehumidifier to operate.
6. If on, the unit will resume operation once the bucket is in the proper position.
NOTES:
o
When removing the bucket, do not touch any parts inside the unit. Doing so may
damage the product.
o
Be sure to place the bucket back gently all the way into the unit. Forcing the
bucket in or failing to place the bucket in the proper position may cause the unit
not to operate.
o
If the pump inlet shaft drops when removing the bucket, reinstall the pump inlet
shaft properly before placing the bucket back into the unit.
o
When the bucket is removed, the unit will beep 8 times while displaying the error
code “P2”. The unit will automatically turn off when the bucket is removed.
