S
SE
EC
CTTIIO
ON
N 2
2
"
Installation
6400 Vehicle Dock Installation Instructions
2
2--1
15
5
Table 2-3
V
Ve
eh
hiicclle
e M
Mo
ou
un
nttiin
ng
g K
Kiitt 2
20
03
3--4
47
71
1--0
00
01
1
Description
NPN
Qty
Phillips head screws #8 x 3/4”
801-289-000
4
Nuts #8
802-114-000
4
Flat head washer #8
803-085-000
4
IIn
nsstta
alllliin
ng
g tth
he
e D
DC
C--D
DC
C P
Po
ow
we
err
C
Co
on
nv
ve
errtte
err
This is an autoranging power converter that accepts a direct current
(dc) input voltage (12 V dc or 24-48 V dc). The output is a regulated
and filtered 12 volts dc to power the vehicle-mounted computer.
Mount the dc-dc power converter on a ferrous metal vehicle surface.
The distance to the rubber booted connector is about three feet from
the converter and three feet from the power source (battery). Any
bends made during cable routing will further reduce the distance be-
tween vehicle batteries and the dock itself.
The converter should be located where it will not be exposed to mov-
ing vehicle components, and at the same time allow easy access to the
On/Off switch on the converter. The four magnets on the bottom of
this converter hold it securely to any large ferrous metal vehicle sur-
face.
FFiin
na
all C
Ca
ab
blle
e C
Co
on
nn
ne
eccttiio
on
nss
C
Co
on
nv
ve
errtte
err tto
o P
Po
ow
we
err S
So
ou
urrcce
e C
Ca
ab
blle
e
The converter to power source cable is hardwired at one end into the
power converter, and contains a white (negative) and black (positive)
exposed wires for power source connection at the other end. The cable
contains a rubber, waterproofed, in-line keyed connector for easy sepa-
ration to service or install the power source cable.
