S
SE
EC
CTTIIO
ON
N 2
2
"
Installation
2
2--6
6
6400 Vehicle Dock Installation Instructions
P
Po
ow
we
err C
Ca
ab
blle
e A
Asssse
em
mb
blly
y
The power cable must have an in-line fuse installed before making final
connections to the vehicle battery. You must also crimp a 3/8 inch ter-
minal ring to the end of the white wire.
A
Asssse
em
mb
blliin
ng
g tth
he
e IIn
n--lliin
ne
e FFu
usse
e H
Ho
olld
de
err
Refer to Figure 2-2 for help with completing this procedure. The in-line
fuse holder consists of a rubber boot, two crimp-type fuse clips, and a
fuse.
This fuse holder may be preassembled, in which case you should skip
the following fuse holder assembly procedures and go to the next set
of instructions, Connecting the Fuse Holder on page 2-9.
If the fuse holder is not preassembled, carefully follow these instruc-
tions to assemble the in-line fuse holder.
1. Locate the in-line fuse holder components.
2. Cut the black wire in the power cable midway between its end
and the cable jacket. Save the 6-7 inch length of black wire.
3. Strip 1/4-inch of insulation from the black wire that extends from
the power cable; also strip 1/4-inch of insulation from both ends
of the 6 inch length of black wire saved in step 2.
4. Slide the longer portion of the in-line fuse holder boot (yellow
rubber) over the black wire that extends from the power cable.
5. Slip a fuse clip onto this wire and crimp the clip onto the wire.
6. Slip the remaining fuse clip onto one end of the 6 inch wire saved
from step 2 and crimp securely.
7. Slide this wire into the other half of the fuse holder boot. Insert
the fuse into the fuse clips and snap the halves of the fuse holder
boot together.
8. Go to Terminating the Wire Ends.
