Intermec EasyCoder 501XP, Руководство по обслуживанию

Страница: 71 / 210

Intermec EasyCoder 501 XP & 601 XP – Service Manual 69
Chapter 8 Print Unit
Description (EasyCoder 501 XP and 601 XP)
The printing is produced by the thermal printhead, which consists
of a line of very small, closely spaced resistors on a ceramic tile
fi tted across the media path. When a current is led through the resis-
tors, commonly called “dots,” these will be heated very quickly.
When the current is shut off, the dots cool down just as fast.
As the media is fed past the dots, the hot dots will produce a
number of black spots on direct thermal media, or on other face
materials via a thermal transfer ribbon. The spots can be combined
into patterns, which make up letters, bar codes, or images.
The direct thermal printing method requires special media coated
with a thin layer of heat-sensitive chemicals. As the media is fed
past the dots, the heat from the dots will make the chemicals react,
producing a dark salt, which makes up the imprint under each dot.
In the thermal transfer printing method, a special “ink”-coated
transfer ribbon is used. When the ribbon is heated by a dot on the
printhead, the “ink” melts and sticks to the receiving face material,
where the ink immediately becomes solid again, producing a black
spot. The transfer ribbon
does not smear, neither before nor after
printing. Nor do the printed labels smear, even if the printout may
be smudged by extensive rubbing if an unfortunate combination
of ribbon and face material is used. The thermal transfer method
makes it possible to use a much wider range of face materials for
printing, for example papers, boards, plastics, foils etc. However,
an original transfer ribbon from Intermec must always be used.
Information on how to switch between direct thermal and thermal
transfer printing is provided in the User's Guides.
The basis for all measures and positioning in the Intermec Fin-
gerprint programming language is the size of printhead dots. In
a12 dots/mm printhead, each dot has a nominal size of 0.083 mm
(3.28 mils.) This means that a heated dot under standardized condi-
tions will produce a black spot which has a diameter of 0.083 mm.
Depending on dot temperature, exposure time, media and ribbon
characteristics etc., the spot may actually be somewhat smaller
(weak print) or larger (black print), but that does not affect the cal-
culation of distances, sizes, and positions.
The printer’s fi rmware auto-detects the printhead density as well
as the head resistance at startup. The printhead can also be
checked using the Fingerprint instructions HEAD, FUNCTEST,
and FUNCTEST$.
8.7 Printhead