Interlogix advisorone, Руководство пользователя

Страница: 83 / 122

83
Contents Index
AdvisorOne User Manual 1.9.x 466-
4421 • REV A • ISS 14APR2016 ©2016 United Technologies Corporation
Outputs
The Output Test (Figure 76) checks the Internal (Piezo) Siren, the External Siren, the
Relay, and any other outputs that are configured.
When the On button is pressed, the output activates. In the case of pressing ON for the
Internal Siren, the system applies power to the siren. The siren stays on until the button
is pressed again or the Output Test window is closed. If the test is left on and the
window left open, the window closes automatically after four minutes.
Note: The sirens are designed to make a very loud noise. The volume level of the
sirens cannot be adjusted.
Test other outputs in a similar manner.
Figure 76: Output Test
Depending on the situation, it may be necessary to contact the central monitoring
station before testing sensors.
1. From the Test screen, press OUTPUTS .
2. Press On next to the output to be tested.
The siren or output turns on. The siren stays on until the button is pressed again
or the Output Test window is closed. If the test is left on and the window is left
open, the window closes automatically after four minutes.
3. Press Off to stop the test.
4. Press CLOSE to exit.
5. If the central monitoring station was notified, inform them that this operation is
complete.