© DDMONYY UTC Fire & Security. All rights reserved.
1 / 2
P/N 46-667
• REV K • 7MAY18
Learn Mode Water Resistant Pendant Panic
Button Installation Instruction
Product Summary
The 60-578 Panic Button can be used throughout the
premises for police, medical or auxiliary alarm activation.
When the sensor button is pressed, the built-in transmitter
sends a signal to the panel (see Figure 1).
Figure 1:
60-578 Pendant Panic Button
The water-resistant design helps prevent damage in case
the sensor accidently gets wet.
The sensor can be worn using the built-in belt clip or it can
be mounted on a wall in a location convenient for the
customer, using the optional wall-mount holder (kit number
80-116). Each kit includes the following:
(5) wall-mount holders
(5) pieces of double-sided tape
(10) plastic anchors
(10) Phillips-head screws
You will also need a small Phillips screwdriver (if installing
the optional wall-mount holder).
Installation Guidelines
Use the following guidelines when installing this button:
The transmitter in the button has an open-air range of
up to 1,000 ft. (305 m), but the installation environment
may influence this range.
When mounting on a wall, determine the best location
for each panic button so it is easily accessible.
The 3.5 VDC lithium batteries will last at least 12
months.
Installation
You can mount the optional wall-mount holder, using
anchors and screws or double-sided tape.
To mount the holder with anchors and screws:
1. Place the holder on the wall at the desired location and
mark the mounting holes with a pencil (Figure 2 below).
Figure 2:
Mounting with screws
2. Secure the holder to the wall with the screws supplied.
Use the anchors supplied where studs are not present.
To mount the holder with double-sided tape:
1. Peel off the colored backing from the double-sided tape
and place it on back of the holder (Figure 3 below).
Figure 3:
Mounting with double-sided tape
2. Peel off the other backing and firmly press the holder
against the mounting surface.
