Intergraph Zx10 Ultra-Tower, Системное руководство

Страница: 91 / 100

79
P9 Connector Pinout
Pin Signal Pin Signal
1 +12.0 V 3 Ground
2 Ground 4 +5.0 V
400 Watt Power Supply
The 400 Watt power supply has a manual switch for selecting either 115 VAC (90-132 VAC)
range or 230 VAC (180-264 VAC) range for domestic or international locations. The input
frequency is 47-63 Hz, single phase. Input current is 8 amps maximum for the 115 VAC range and
4 amps for the 230 VAC range. The power supply has a minimum efficiency of 70 percent at
maximum output load. The power supply is enclosed in a case that includes a fan for additional
airflow through the system.
The power supply has the following DC output specifications.
Outputs
→
1 2 3 4 5 6
1
Nominal Output Voltages (VDC) +5.0
2
+3.3
2
+12.0 -12.0 -5.0 +5.0
Maximum Current Rating (ADC) 40 40 15 0.5 0.5 1.5
1. S5.0 VDC output voltage is always on.
2. M5.0 V and +3.3 V combined power is 300W.
The power supply has two power cables, P1 and P2, that connect to ATX power connectors on the
system board.
The power supply has six peripheral device power cables (P3, P4, P5, P6, P7, and P8) and one
floppy disk drive power cable (P9). These cables connect in daisy-chains to the power supply and
to each other as follows:
Power supply
→
P3
→
P4
Power Supply
→
P5
→
P6
Power supply
→
P7
→
P8
→
P9
P1 Connector Pinout
Pin Signal Pin Signal Pin Signal Pin Signal
1 +3.3V 6 +5.0 V 11 +3.3 V * 16 Ground
2 +3.3V 7 Ground 12 -12.0 V 17 Ground
3 Ground 8 Power Good 13 Ground 18 -5.0 V
4 +5.0 V * 9 5.0 V Standby 14 Remote On 19 +5.0 V
5 Ground 10 +12.0 V 15 Ground 20 +5.0 V
* + Sense