Interflex IF-4735, Техническое руководство

Страница: 22 / 25

16 Configuring the Device
6.5 Updating software
In order to update the software, the
PuTTY
program package must be installed on the service PC.
Updates are performed by means of batch files and the Windows input prompt
cmd.exe
.
The update files should be located in the same folder as the batch files, to avoid error messages.
The following batch files are available:
File name Purpose
setpathvars.bat
You require this file for all updates. You can enter the system password
here in order to make it invisible in
cmd.exe
. You can also change the
paths of the programs
pscp.exe
and
plink.exe
here, e.g. in the event
of an update using a USB stick (default:
C:\Programs\PuTTY
).
tc802-1x-cert.bat
Loading/exchanging the client certificate that is required for authentication
in acc. with IEEE 802.1X (EAP-TLS with X.509 client and server
certificates).
tclicence.bat
License file replacement. Necessary when upgrading the device’s license.
tcdiag.bat
Gathers diagnostic information on the device in a file which is saved in the
same folder as the batch file.
tctermfwup.bat
Firmware update via the network of the controller or recording unit
tcswup.bat
Software update of the device
Performing update
Start
cmd.exe
and run the desired batch file:
File name Command
setpathvars.bat
setpathvars.bat
(displays the paths of
pscp.exe
and
plink.exe
)
tc802-1x-cert.bat tc802-1x-cert.bat <Certificate> <IP address controller>
tclicence.bat tclicence.bat <License file> <IP address controller>
tcdiag.bat tcdiag.bat <IP address controller>
The file with the diagnostic information is saved in the same folder as the
batch file. Name:
tc_<IP address controller>_diag.tar.gz
tctermfwup.bat tctermfwup.bat <terminal firmware file> <IP address
controller>
The terminal number is hard-coded in the batch file, e.g.:
sh% -pw %ctrl_password% root@%2 "%dest_bin_dir%/etp
1
-fun %1
Updates to multiple controllers are performed individually for each one. To
do so, open the batch file in an editor and change the number of the
controller.
tcswup.bat tcswup.bat <TC software file> <IP address controller>