Intellisystem ThermalTronix TT-1040S-UTCM, Руководство пользователя

Страница: 14 / 17

13
3.2.8. Image enhancement setup
Setup: Press MENU button until E: XXX option is selected. Press UP button or DOWN
button to set needed enhancing state.
Exit: Press MENU button until Exit : option is selected and press UP button or DOWN
button to exit.
Note: Image enhancement can improve the observation effect, but may decrease the
Signal-to-Noise. This function is disabled in Mode 8.
3.2.9. Crosshair setup
Setup: Press MENU button until C: XXX menu option is activated; Press UP button or
DOWN button to setup needed enhancing state.
Exit: Press MENU button until Exit :option is selected and press UP button or DOWN
button to exit.
Note:
Set the calibration parameter if the images are non-uniformity
3.2.10. Dead pixel correction setup
Setup: Manually Setup: press F button and UP button at the same time to activate dead
pixel correction setup. Press UP button or DOWN button to move crosshair central
dot to dead pixel position, and then press C button (calibration function) to replace
current dead pixel (press C button again to cancel).
Exit : Press MENU button to select Esc , and then press UP button to exit.
Note: If immovable dead pixel exists in the image, calibration can not be done by pressing C
button to activate dead pixel correction setup.