[3]
Polarity Switch
-
Sets whether the
voltages sent from
CV A
[G]
and
CV B
[H]
are
Unipolar or Bipolar:
●
UNI
(UP) : In
this position, the
voltage sent out CV A or CV B is +5V at the maximum level, and 0V at the minimum level.
●
-/+
(DOWN) : In this position, the voltage sent out CV A or CV B is +5V at the maximum
level, and -5V at the minimum level.
[4]
LEDs
- These indicate the amount and polarity of the voltage sent out
CV A
[G]
(left LED) and
CV B
[H]
(right LED) jacks.
Green
indicates a positive voltage, while
red
indicates negative.
The brightness of the LED reflects the absolute voltage level.
BACK PANEL
Aside from the usual power connector, the back panel also contains a 3-pin Link connector, and
each XFADE 1U module ships with one 3-pin Link cable. Use this to connect XFADE 1U’s MIX
output to the input of a compatible, 3-pin equipped Intellijel module (such as a
Mixup
), or to the
3-pin Link connector that feeds the output jacks on your Intellijel
7U
or
Palette
case. See those
manuals for more information. Using the 3-pin Link cable negates the need to patch the
MIX L Out
[E]
and
MIX R Out
[F]
jacks to your Mixup or audio output module via the front panel.
IMPORTANT
: Never use the 3-wire Link cable to directly connect a XFADE 1U module to an
Intellijel
Pedal I/O
module. Although both modules use this same cable/connector — they serve
different purposes and carry different signals.
TECHNICAL SPECIFICATIONS
Width
26 hp
Maximum Depth
38 mm
Current Draw
48 mA @ +12V
41 mA @ -12V
XFADE 1U Manual
10